Sample cutter or cutting plotter use and maintenance
The cutting head is mainly composed of a transmission mechanism and a cutter mechanism. The cutter is mainly composed of a curve along the X and Y axes, a rotary motion around the C axis, and a vertical up and down reciprocating motion at a high frequency.
1. Before using the Cash Register Roll Slitting Machine, lubricate the spring groove at the left and right ends of the cutter before use, and lift the cutter up and down several times by hand. The purpose is to make the cutting tool smooth. Secondly, the active parts and connecting rods need to be lubricated.
2. What is the reason when the cutting knife can not be lifted:
⑴ It should check whether the travel switch and cam in the cutting machine are normal, whether the cam screw is loose;
⑵ The cam can be twisted by hand to try cutting;
⑶ Check if the connecting rod of the transmission is rusted or not smooth.
⑷ Is the spring before cutting not too tight and there is no refueling.
3. When the cutting machine is placed, the closer to the printing machine, the better the paper exit position. For example, the cutting tape can be used to remove the iron piece attached to the machine, and the tape is wrapped with a paper sleeve, and then the knife edge is placed. Use a cardboard to hold the tape, in a word: try to cover the tape as much as possible to cut it smoothly.
4. The cutting knife is blunt, you must take back the sharpening knife, or cut the continuation, master the skill, the cutting machine can be used very well.