What are the reasons for the paper breakage of the Thermal Paper Slitting Machine
In the process of using the slitting machine, we often encounter the problem of paper slitting and rupture. These problems may cause us a lot of troubles. When the problem is serious, it may directly affect the progress of the whole production, resulting in a very The results that you are willing to see; there are many reasons for the problem of paper slitting and rupture. The most common cause is the small knife on the slitting knife or sawing. The following six conditions are common.
1. The small mouth is not open in the direction of paper movement, too much on both sides.
2. The small mouth is not stuck inside the product box or folded inside.
3. When there are inconsistent small holes in the paper, there is no small hole in the die cutter in the paper cutting direction, so that the waste paper in the small hole falls on the steel plate and is dragged into the creasing line. Inside, the product folds are broken.
4. When the paper is thin, the strength of the paper is large, and the opening is too much, deep and wide.
5. If the box edge of the product box is flat, the opening should be more, deeper and wider. If the box edge of the product box is hook-shaped, since the paper edge and the product will hook each other, the opening can be small, shallow and narrow.
6. The faster the machine works, when it is pulled out from the stopped molding position, the acceleration is large, the pulling force is also large, the connection point on the printed sheet is too small, the opening is too small, too shallow, too narrow, and then the broken.