How To Debug The Speed Of Automatic Cross-cutting Machine

- May 14, 2020-

1. There is no need to feed during commissioning, but you must first adjust the guide screw on the guide plate upward, and then slowly adjust the punch hammer to the bottom dead center by inching, and you must pay special attention to the guide plate not to press the floating rod The lower is too low, otherwise it will cause the floating rod to bend or break.

    2. When the automatic cross-cutting machine is started to work continuously, the speed of the feeder must be adjusted in a clockwise direction, and the slider movement is slightly slower, so that it can be seen whether the slider touches the nylon gasket and the length is finely adjusted. Screws.

    3. During the test, the slider moves back and forth. If only the nylon gasket is touched but the length fine adjustment screw is not touched, this is because the floating rod is not deep enough, and the guide screw on the punch machine needs to be adjusted down slowly.

    4. If the slider moves back and forth, the automatic cross-cutting machine only touches the length fine adjustment screw and does not touch the nylon gasket. This is because the floating rod descends too deeply, and the guide screw on the punch machine needs to be slowly adjusted upward.

    5. If the slider moves between the length fine adjustment screw and the nylon gasket and the distance between the two sides is equal, then the speed adjustment screw needs to be rotated in a counterclockwise direction to make the slider speed normal and make the slider can be encountered when reciprocating. Nylon gasket and spacer ring.

    6. If the speed of the automatic cross-cutting machine does not change, and the feeding distance needs to be changed from long to short, first adjust the guide screw upward to reduce the descending distance of the floating rod, and then rotate the speed adjustment screw clockwise, so that the feeding can match the punch speed .

    7. If the speed of the automatic cross-cutting machine does not change, and the feeding distance needs to be changed from short to long, first adjust the guide screw downward to increase the descending distance of the floating rod, and then rotate the speed adjustment screw counterclockwise, so that the feeding can match the punch speed .

7