This Label Die Cutting Slitting Machine or label die cutter adopts flat bed high accurate die cutting, label feeding and sheeting controlled by touch screen micro-computer, the two sides of printed mark and longitudinal tracked by three photoelectric eyes. Die cutting rewind waste edge side paper, sheeting can finish at one time. It is suitable for die cutting paper label, film label and holographic label etc. This machine is necessary auxiliary label die cutting machine for the flexo printing machine or continuous screen printing machine.
Number of lines
The number of lines of the anilox roll refers to the number of ink holes in the unit length of the anilox roll surface, and is also one of the important parameter indexes of the anilox roll, which also has a very important influence on the ink transfer performance of the anilox roll. In general, the higher the number of lines of the anilox roll, the smaller the amount of ink transferred, and vice versa. In addition, the number of lines of the anilox roller also determines its own range of application. In general, when printing large areas of solid color patches or images that are not too high, it is conceivable to use a low number of anilox rolls, such as an anilox roll of about 360 lines per inch when printing a solid area. On the contrary, when printing fine images or small characters and lines, an anilox roller with a relatively high number of lines should be used to prevent the gradation of the hue value from being greatly immersed in the ink hole due to the small dot size in the high light region, or extremely fine. The lines are thicker. However, the number of lines of the anilox roll should not be too high. If the number of lines of the anilox roll is too high, it will not only cause certain difficulty to the processing process of the anilox roll, but also, due to the mesh wall of the high-line anilox roll. When the thickness is thinned, the strength is lowered and damage is likely to occur, that is, if the number of lines of the anilox roller is too high, the service life is accordingly shortened. In general, the number of lines of the anilox roll is four or five times the number of screen lines for the print job. Of course, it must also be combined with the actual situation of the actual production of the printed image.