1. Paper slicer must slice the whole roll or sheet of raw materials with fixed length, such as plastic packaging materials, packaging cartons, steel plates, film, leather, wood chips and so on. It must use fixed length slitting control.
2. The cutting length can be set continuously. If the actual cutting length has errors, it is easy to calibrate by setting parameters.
3. The slitting control of paper Slitter can be divided into two kinds: static and dynamic slitting: accurate shutdown when the set length arrives, then static slitting processing, restart operation after slitting; when the set length arrives, non-stop slitting signal is sent out, and dynamic slitting processing is carried out in the course of material movement.
In the middle of the paper tube splitter, a spindle for processing paper tube is installed. The front end of the spindle is fixed on the base with a group of bearings, and a belt pulley is installed in the middle of a group of bearings. A compressed cylinder is installed near the base, and a set of support rod bearings are installed at the upper end of the support rod of the cylinder to support the spindle.
The upper end of the paper tube splitter is equipped with a main knife shaft, on which a number of blades are arranged according to a certain gap, and a support frame of the main knife shaft is also provided at the top of the paper tube splitter, and a support cylinder is installed in the middle of the support frame.